Mark Kettle's EPP Vulcan

Just ordered one of these wicked looking machines - an EPP Vulcan. Thanks Steve A70 for the heads up!

Designed and manufactured by Mark Kettle for £79 delivered (limited offer - limited availability)

Here what you get for your money.

List of Vulcan parts

Two inner wings with engine locating slots in trailing edge

Four outer wings with elevon mounting step in trailing edge

Two Foam elevons taped to lite-ply

12 Fuselage parts  - Fin with woods  - Cockpit   - 4 foam nacells

Plan - Build instructions - Various inserts

Five Spars 6 mm  - min size - woods  - some bevelled ends & marked where to use them in wing

Two triangle 6 mm spar support

Two Inner front fuselage 1.5 mm ply sides

Connected as one -two lite ply 30 x 3 mm used on base inside fuselage - marked on where to use

One roll velcro - 0.5 mtr x 20mm wide -to be used with above lite-ply for ballast holding and removeable front ply for battery, RX placement and nose weight.

One 1.5mm ply hatch markings  - magnets 10mm dia x 2mm wide with    - warning note - and a  skewer

Some non-stick paper -  40 grade grit sanding block - soft sanding pad used when decorating - brown parcel covering paper

UHU contact adhesive  - PVA 500 ml doesn’t need thinning  - Tub of Lite Filler 400 ml size

Control parts Two 30 x 20  x 6 mm wooden blocks to take screws under lite-ply -horns x2 -screws x4 -clevis x2 -rods 2 mm x2 -2 mm balsa  servo hatch x2 marked with slot for standard size servos One elevon measuring tool printed on photo paper

Box  - free Postage delivery  -

If your interested (like me) then you can contact Mark on 07958 772 123 or email him on markskettle@gmail.com